Sigma post roll forming machine
Advantage:
1. Variable frequency speed control
2. Latest type,little noise
3. High precision in forming and cutting
4. High efficiency
5. Widely use
Note: we can design and produce machine according to your special size requirement.
Description:
Metal roll forming machinery consists of uncoiler and its base, coil sheet guiding equipment, roll forming system, post-cutting equipment, hydraulic station, controlling system, supporter table, the corrugated profile sheet produced by this machine has high strength with big rib, which adheres well to concrete, it’s best to be used as the floor of high buildings, and the cost of such floor is low
Machine specification:
Technical Datas roll forming machine |
1 | Material width | As your profile drawing |
2 | The effective width | As your profile drawing |
3 | The thickness of Coil | 2-4mm |
4 | Application | wall sheet and roof sheet |
5 | The overall dimensions | 6800mmX1500mmX1300mm |
6 | Total weight | 5 Tons |
7 | Main Power | 11 KW |
8 | Uncoiler | Manual Uncoiler |
9 | Inner diameter | 508--610mm |
10 | Outer diameter | 1200mm |
11 | Loading weight | Max 5T |
12 | Forming speed | 10—12m/min |
13 | Forming steps | 10 stations |
14 | Bracket | welded with 36 # I-steel |
15 | Material of Shafts | 45# steel with rough finished and then refined finished |
16 | Diameter of the Roll | 76mm |
17 | Material of Rolls | high quality 45#steel coated with hard chromium 0.05mm |
18 | Processing Technology | rough processing ---refined processing--Hard Chromium Plating. |
19 | Material of Rack | complete welded structure of A3 steel plate 16mm thickness |
20 | Transmission | Gearbox T180 |
21 | Material of Chain | 45#steel with heat treatment of HRC45- 50° |
22 | Holders under chain for lubricant | By the machine |
23 | Material of cutting blade | Cr12 with quenched treatment 60-62 |
24 | Cutting system | Hydraulic cutting |
25 | Voltage | 380V/50HZ/3phase |
Machine picture: